I first stamped the trio pumpkins from Autumn Days stamp and masked off the bottom part so that I could create the ground with the twigs for the pumpkins to stay on. I also stamped the pumpkin with leaves at another side of the card. I wanted it to be interative card so I stamped the trio pumpkin again but only colored the top one and fussy cut it out as well as the skull from Sugar Skull Amor.
Here is the closer look
I took some photos along the way when I created this project and I included them here
After I colored the images with copic markers I cut the panel with Picture Frame dies and prepared my interactive elements as shown above. I also pucked holes at the middle pumpkin eyes for my LED light.
I provided the space for my magnetic strip using double layers of form tapes.
This is after I run the copper tape to the battery. I made sure that my form tape aroun the battery were a bit higher the height of the battery itself.
I then put form tapes all over even on the copper tape. I also put the stopper at the end of the track. I peeled off all the form tapes backing except the stopper that I put red circle on. Before I put another piece of card stock to close it up, I put the magnet strip on the track and made sure that the battery is facing down. If I ever do this type of card again I'll use a thicker paper for the pulling machanism for more durability.
And the back panel was ready to be sealed.
And here is the finished card front after attached on the black card base.
I also sprinkled Fall Harvest sequins here and there to finish off my card.
I made a short YouTube vdo showing the card in action. I hope you like it and Thank you for stopping by today. Have a Wonderful day my friends!
No comments:
Post a Comment